The most water-saving installation skill basin faucet should be installed like this

The faucet is a must-have product for the kitchen and bathroom. We can't measure it by the size of the head. However, everything is a double-edged sword, bringing convenience and a lot of troubles. The failure of the faucet is largely not the only quality decision, and its installation module also occupies a small position. Xiaobian specially brought faucet installation skills to everyone, the most water-saving installation method, have you mastered it?

The installation requirements for the single-hole Kitchen Faucet are stable, because the kitchen faucet is frequently used, and it is moved and moved, so it is easy to loosen, so the lock nut must be tightened. Now there are some faucets on the market for the screw to increase the nut fixing. This kind of stability effect is very good. If it can solve the problem of water removal, it will be a popular trend in the future.

Installation of single-hole basin faucet When purchasing a single-handle basin faucet, attention should be paid to the diameter of the water outlet. Most of the market is now a hard-tube inlet, so you should pay attention to the height of the water inlet, which is most suitable from the basin down 35 cm. When installing, be sure to choose a special angle valve, and the angle valve must be fixed with the hot and cold water pipe of the wall outlet.

When you find that there is a distance between the angle valve and the water pipe on the faucet, be sure to purchase a special extension tube to connect. Do not use other water pipes to connect, because if the water pressure is too large, it will easily fall off and leak, causing you loss. If the inlet pipe is too long to exceed the outlet pipe, you can cut off the part according to your needs. If the angle is not suitable, bend it to the position you need as needed. Do not bend hard to 90° or greater than 90°. When you go to the basin to remove water, don't forget to buy a small interface for the faucet. Don't forget to flush the water pipes buried in the wall before you install it.

Before installing the thermostatic faucet, please check if the water pipe is left hot and right cold. Do not connect the hot and cold water pipes incorrectly, so as to prevent the faucet from working properly. Gas and solar water heaters cannot use thermostats because the water pressure is too low. Do not forget to install the hot and cold water filter when installing the thermostat.